Marshall EL34 100/100
Marshall EL34 100/100 Buy Today & We'll Throw In The Following Free Gifts! Free Deluxe 20FT Instrument Cable, Free Korg GA30 Tuner! This is a limited time offer so please act quickly! Marshall EL34 100/100 Description: Marshall EL34 100/100 Introduction EL34 100/100 the specially designed Marshall 'Gold' front panel provides a deep recess in which the controls are sited giving a smooth uncluttered finish, whilst allowing the controls to be set, with little fear of accidental re-adjustment. The two power amp halves of your EL34 50/50 or EL34 100/100 are totally separate 'MonoBlocs', a feature that is normally only found on expensive valve hi-fi power amps. This means that the only common electrical item (apart from when specifically cross linking inputs) is the mains supply and that nothing that occurs to one power amp can sonically react with the other half. Also in the unlikely event of one side breaking down, the other side will carry on working regardless. Our constant research into valve amplifier technology has resulted in further circuit design improvements which dramatically affect the overall feel and playing response of your Marshall valve power amp. These improvements include Marshalls latest True Differential Inverter technology, which expands the capability of the phase splitter (inverter). Put simply, the phase splitter takes the incoming signal and inverts half of it. This inverted half of the signal forms the bottom half of the sound envelope and the non-inverted half forms the top half. The effect of T.D.I. technology is to give a more defined spectrum of sound over a broader band width, without compromising the overdrive and compression effects for which valve amplifiers are famed. This also allows more radical uses of feedback networks and the incorporation of the 'voicing' switching found on each channel. These incredible 'voicing' options, which can be remotely activated, can be used to greatly expand your pre-amps tone forming at the flick of a switch. Mounting the Power Amp in a Rack To allow the secure fastening of 19 inch rack units in a rack enclosure, a series of mounting holes are provided on the front of the EL34 100/100. As with all rack mount products of substantial weight, such as the 100/100, the rear of the unit must be supported as well as the front, therefore suitable brackets should be obtained and fitted between the provided rear mountings and the rack case. It should always be remembered that valve amplifiers generate a certain amount of heat, therefore they should never be mounted, or used, in any situation without adequate airflow. The 100W + 100W EL34 100/100 utilises the 'industry standard' Marshall EL34 driven, valve power stage. When you hear the EL34 100/100 you will immediately appreciate this tonal heritage. An eye-catching and innovatively designed unit, it is packed with Marshall valve tone. Just like expensive hi-fi amps, the EL34 100/100 is a Dual MonoBloc amplifier - meaning that each si